Skill Level: Intermediate
Estimated time: 5 hours
DIY
Jewelry Organizer
No more tangled necklaces! Build this functional and decorative jewelry organization unit to hang up in your bedroom, bathroom, or closet.
Copyright © 2018 Black & Decker Inc. All rights reserved. "BLACK & DECKER", "BLACK+DECKER", and the BLACK & DECKER and BLACK+DECKER logos and product names are either registered trade marks or trade marks of "The Black & Decker Corporation".
1. Cut Wood to Size
Use your jigsaw to cut the 1 x 3” wood into six pieces, each 16" in length, and one at 14" (the shorter piece will be used as your back fastening piece).
4. Re-Trace + Cut
2. Trace Half of Heart
Line up pieces of wood. Draw half of a heart into one side of the pieces, as seen in image below. (After you cut the first three pieces you’ll flip them and trace them onto the remaining three pieces so that your project is symmetrical.)
3. Cut Tracings
Secure wood to work bench and cut tracings with jigsaw. For smaller pieces, you may want to use clamps.
What Tools You'll Need
IMPORTANT SAFETY INFORMATION
To reduce the risk of personal injury and property damage, read and follow all related product manufacturers instruction manuals and information before performing any of the applications shown. Some construction-related applications shown may not be allowed in your local area. Consult your local authority having jurisdiction (AHJ) before starting work for information on permits, applicable codes, and other regulations. Black & Decker disclaims any responsibility for any damage to property or injury to persons as a result of misuse of the information provided.
"Black & Decker” – © Copyright 2019, Black & Decker Inc. All rights reserved. “BLACK&DECKER,” “BLACK+DECKER,” and the BLACK&DECKER and BLACK+DECKER logos and product names are either registered trademarks or trademarks of the “Black & Decker Corporation”
18V CORDLESS DRILL
MOUSE DETAIL SANDER
WORKMATE WORK BENCH
GLOVES
SAFETY GLASSES
Check Out The Step By Step Video
Buy Online
5. Sand All Pieces
Using the BLACK+DECKER MOUSE® Detail Sander, sand all edges until they are soft and line up with each other.
6. Drill Pilot Holes
Using your BLACK+DECKER 12V MAX* Cordless Drill/Driver and a 1/8" drill bit, drill six pilot holes that are spread evenly apart in the 14" piece of wood. This is the piece you will use to connect the six vertical pieces. Next, drill one pilot hold in each of the vertical pieces.
7. Pain/Stain
Now that you have sanded and cut pilot holes in your heart, paint or stain the pieces any color that you want. We alternated between paint and stain. Let dry! (Follow instructions on paint or stain bottle for appropriate length of time.)
8. Fasten Back
Now that your pieces are dry, secure the 14" slat to the back of your painted vertical pieces using #8 screws and wood glue.
9. Attach Knobs
First drill pilot holes where you want your knobs to be. Then screw in knobs using hardware included in knob packaging.
10. Attach D-Rings & Hang Up Your Jewelry Hanger!
Attach D-rings to back of 14" wood using screws and hardware provided.
Fasten screws into wall and hang up your heart-shaped jewelry hanger!
TIP: Find studs using a stud finder. Screw into studs to ensure your jewelry is supported.
520W JIGSAW
Sharing Is Caring!
Invite Your Friends & Have Fun Doing It Yourself!
PRODUCTS
HOME